1. Understanding Normally Open and Normally Close concept of PLC
2. AND OR EXOR Instruction
3. Example of AND OR EXOR Instruction in Siemens TIA Portal
4. SET RESET Instruction
5. Example of SET RESET Instruction in Siemens TIA Portal
6. SET RESET and RESET SET Flip-Flops
7. Example of SET RESET and RESET SET Flip-Flop in TIA Portal
8. NOT Instruction
9. Example of NOT Instruction in Siemens TIA Portal
10. EDGE Detection Instruction
11. Example of Positive and Negative EDGE Instructions in TIA Portal
12. Pulse Timer Instruction
13. Example of Pulse Timer Instruction in TIA Portal
14. ON Delay (TON) Timer Instruction
15. Example of ON Delay Timer in TIA Portal
16. OFF Delay (TOFF) Timer Instruction
17. Example of OFF Delay Timer in Siemens TIA Portal
18. Retentive Type ON-Delay Timer (TONR)
19. Counter UP Instruction
20. Example of Counter UP Instruction in TIA Portal
21. Counter DOWN Instruction
22. Example of Counter Down in Siemens TIA Portal
23. UP and DOWN Counter Instruction
24. Example of UP and DOWN Counter in TIA Portal
25. Understanding Comparison Instruction Using TIA Portal
26. Jump Instruction
27. Example of Jump Instruction in TIA Portal
28. Understand ADD MUL SUB DIV Instruction using TIA Portal
29. Calculate Instruction
30. Example of Calculate Instruction in TIA Portal
31. Round Instruction
32. Example of Round Instruction in TIA Portal
33. NORM X and SCALE X Instruction
34. Example of NORM X and SCALE X Instruction in Siemens TIA Portal
